Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
Use of non genuine Hayward manufactured parts will void all warranty.
K487BLU REV A
12
Hayward only guarantees the quality, performance and safety of its products when assembled with genuine Hayward manufactured parts.
Use of non genuine Hayward manufactured parts will void all warranty.
Approximately eighty percent (80%) of the dirt in a concrete pool will be on the floor of the pool. Approximately twenty
percent (20%) of the dirt will be on the walls. Your Hayward Blu cleaner will spend its cleaning time accordingly.
Due to the shape (severe angles) of many in-ground vinyl liner pools, the Hayward Blu
’s cle
aning capabilities may be
confined to the bottom (both shallow and deep) and the hopper sides. Hayward Blu may not climb the vertical walls of
some vinyl liner pools. However, normal dirt and debris do not typically adhere to these types of walls in a vinyl pool.
… … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … … ….
DO NOT COIL HOSE
When storing your cleaner the hose sections must be stored straight rather than coiled. A coiled hose will create a
memory in the hose that will significantly reduce the Hayward Blu
’s ability to move properly in your pool.
Coiled hoses are
not covered under the Hayward warranty. When removing the Hayward Blu from your pool, be sure to grasp the cleaner
by its handle rather than the hose to prevent damage to the cleaner. Always disconnect the hose from the cleaner when
removed from the pool to prevent memory damage to the hose.
1. Skimmers come in many configurations and cannot all be described in this manual but the three most common types
are covered below:
Many skimmers have two (2) holes in the bottom. There may be a float valve or cover plate over the holes. Remove
everything in the skimmer, exposing the holes. The rear hole is usually the suction port. In some cases it will be
necessary to use the (V094) regulator valve to control water flow to the Hayward Blu cleaner (See Figure 4).
Some skimmers have only one (1) hole in the bottom. In this case the suction port is usually controlled by the valve at the
filter system and most likely will not need (V094) regulator valve (See Figure 3).
220318_BluManual_r3.indd 12
1/14/13 1:27 PM
