08/18
Model 2000SMS
Page 2 of 6
INSTALLATION PROCEDURE
NOTES:
1. This unit is certified for indoor use only.
2. For all plastic push-in type fitting connections, only connect NSF-61 copper or plastic
tubing. Stainless steel or glass tubing is not recommended. The following assembly
instructions must be followed to ensure a watertight connection:
a.
Cut tubing square and clean.
b.
Mark from end of tube the length of insertion (See table below).
c.
Push tube into the fitting until it bottoms out.
d.
To remove, depress collet and pull tubing out.
Tube Sizes
O.D. Tolerance
Insertion Depth
1/4”
±.005”
11/16”
3/8”
±.005”
3/4”
1/2”
±.005”
7/8”
2. Use NSF-61 approved pipe joint sealant on all threaded water connections.
3. Do not use with water that is microbiologically unsafe or unknown quality without
adequate disinfection before or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain filterable cysts.
4. Use the cardboard inserts from the box to support the unit while preparing for
installation by placing unit face down on inserts.
5. There is an opening in the bottom of the unit to accommodate a plumbed waste. If a
plumbed waste is desired, the Haws model 6470 retrofit kit may be used.
Step 1:
To open the unit, slide the supplied hex key into the notch in the left-hand side of the hinged
upper plastic panel and press the key firmly in that same direction. This will disengage the
internal spring latch. Simultaneously pull open the hinged panel (see Step 1 Diagram).
Take care not to damage the stainless steel panel or the spring latch in this process.
WARNING: Filter is not intended to withstand operating pressures greater than 100 PSI (6.8
ATM). If inlet pressure is greater than this, filter must be protected with a pressure regulator.
WARNING: Make certain power is disconnected before installation to reduce risk of electrical
shock.
Step 1 Diagram
Step 1 Diagram
