Hawk HA-240 Lite v3, Installation Manual

Page: 9 / 20

6
Pin 14 WHITE / BLACK WIRE: CDL
Pin 15 YELLOW / BLACK WIRE: CDL
Pin 16 YELLOW WIRE:
Negative Output (-) 250mA Immobiliser. Connect to yellow wire to yellow wire to
immobiliser relay.
Pin 17 RED WIRE:
Main Power Input (+). Connect to the battery or constant power wire at the ignition
switch with a minimum 25 amp supply
Pin 18 WHITE WIRE:
Positive Siren Output (+). Connect the white wire to the siren of red wire.
Pin 19 PINK WIRE:
Negative Output (-). 250mA Boot Release. Connect to the boot release motor.
NOTE: MUST USE RELAY (not supplied).
Pin 20 BROWN WIRE:
Positive Hazard Light Output (+). Connect the brown wire to the circuit that shows +12v
or only when the hazard lights are on. Right hazard light.
Immobiliser relay connection guide
Pin 86 of relay YELLOW WIRE:
Connect to yellow wire of alarm system connector (pin 16).
Pin 85 WHITE WIRE:
Connect to first accessory of ignition switch (+12v).
Pin 87a and 30 of relay 2 x GREEN WIRES:
Normally closed, can be connected to starter motor, positive side of coil, for diesel car
fuel pump. See wiring diagram for guidance.
Connected to Hawk Motorcycle Alarm
7