Hawk HA-240 Lite v3, Installation Manual

Page: 8 / 20

Primary harness wire connection guide for 24 pin connector
This guide describes in detail the connection of each wire. Also included are possible
applications of each wire. This system was designed with the ultimate in flexibility
and security in mind. Please read the instructions carefully to ensure a thorough
understanding and how it operates; also see wiring diagram of HA-240 Lite.
Pin 1 ORANGE WIRE: CDL
Pin 2 YELLOW WIRE:
Ignition Input (+). Connect to the main ignition wire that pr12v when the ignition
is on and while cranking the starter. Also, when ignition is off, this wire should not show
any voltage (0v).
Pin 3 BLUE WIRE:
Negative Door Input (-). Connect to the Driver door pin switch circuit wire that shows
ground (-) when the door is open.
Note: Nearly all cars have negative door input. Consult owner manual for polarity.
Pin 4 GREEN WIRE:
Positive Door Input (+). Connect to the driver door pin switch circuit wire that shows +12v
when the door is open.
Note: Consult owner manual for polarity.
Pin 5 RED WIRE:
Negative Output (-). 250mA Window Closer. 30 second negative output.
NOTE: MUST USE window closer module HA-64U (optional extra).
Pin 6 : NOT USED
Pin 7 BLACK WIRE:
Ground Input (-). The black wire must connect to a solid chassis ground. Clean away any
paint or dirt to ensure the best possible ground.
Pin 8 BLUE/WHITE WIRE:
Positive Input (+). Connect the blue/white wire that shows +12v when pressing the foot
brake.
Pin 9 RED/BLACK WIRE:
Negative Output (-). 250mA Interior Light. Connect to the wire that activates the vehicle’s
interior light.
Pin10 BROWN WIRE:
Positive Hazard Light Output (+). Connect the brown wire to the circuit that shows +12v
or only when the hazard lights are on. Left hazard light
Pin 11 WHITE WIRE: CDL
Pin 12 YELLOW WIRE: CDL
Pin 13 ORANGE / BLACK WIRE: CDL
6 7