Haverland HE1200, Manual

Page: 32 / 36

8
No bars
5.7
Automatic Use (Programmed)
Taking into account your personal needs, the heater
provides the possibility to create an individual
programme.
This programme is established according to the day,
time and operating modes: comfort, economy, anti-
icing or standby mode.
1) If the heater is in Standby (Fig.18), press the
“Standby” button to switch it on.
Single upper
bar
Fig. 21
Standby Mode
Fig. 19
• To programme “Anti-icing”, press the “Anti-
icing” button.
(Anti-icing Mode = one single upper bar).
2) Press the “PROG” button for three seconds. The four
clock digits will be displayed.
First, the two “hour” digits will flash. Use the (+) or (-
) buttons to enter the current hour.
Then, press “PROG” to programme the minutes. Enter
the current minutes. Press the “PROG” button.
Single lower
bar
Fig. 22
3) Then, programme the current day of the week. All
the following digits will be displayed, “1, 2, 3, 4, 5,
6, 7”.
Use the (+) or (-) buttons to enter the day of the
week as follows (1 = Monday, 2 = Tuesday etc).
Press the “PROG” button.
4) Programming each day of the week.
Begin by programming the first band for Monday
(1) From 00:00 hours until 01:00 (the first bands will
flash).
An operating mode can be assigned to each hour :
• To programme comfort, press the “Comfort”
button:
(Comfort Mode = one double bar).
• To programme “Standby – switch off”, press the
“Stand-by” button.
Standby Mode = no bars”.
Fig. 23
Programming is performed hour by hour. The
selected hour will flash.
Double bar
Fig. 20
6) Press the “+“ button to select the following time
band. Repeat the heating mode selection process as
required.
Press the “-“ button to return to the previous time
band.
7) When all the time bands for Monday have been
programmed, press the “PROG” button to move on to
the next day, Tuesday.
• To programme economy, press the “Economy”
button
(Economy Mode = one single upper bar).
Repeat all these steps to programme each day of the
week, until Sunday (7) is reached. When Sunday is
programmed, press the “PROG” button to confirm. The
programming mode screen will be displayed containing the
updated values.
3 2