7
5.2
Locking / Unlocking
The heater controls will automatically lock when no
button has been pressed for sixty seconds.
This operation will occur in both manual and
automatic modes.
The heater controls can be unlocked by pressing the
“-“ button on the control panel for three seconds
(Figure 13) or on the remote control.
Note: After unlocking the keypad, the selected
temperature will appear for three seconds with ºC
flashing.
5.3
Using the heater
The heater can operate in manual or automatic mode
(programmed).
5.4
Manual Use
To select
manual mode, press the “PROG” k e y u n t i l
t h e t i m e b a n d s d i s a p p e a r f r o m t h e L C D
s c r e e n (Figure 18).
Manual Mode
(example: Comfort Mode)
Fig. 18
When in manual mode, the desired heating mode can
be selected (comfort, economy or anti-
freeze
) by
pressing the corresponding button (Fig. 13) and the
heater will permanently operate in any of these
modes with the assigned temperatures.
5.5
Changing the selected
temperature
The heater is supplied with a pre-established
temperature for each operating mode, which can be
modified in the following manner:
•
MANUAL - COMFORT MODE:
a) Press the Comfort mode button (Figure 13).
b) Use the (-) or (+) buttons to select the desired
temperature. (Example, select 22 ºC)
c) The selected temperature is saved.
The existing room temperature will be displayed again
after a few seconds.
Note: The comfort mode is recommended for a
comfortable temperature when remaining in the
room.
Recommended temperature: 21 ºC.
•
MANUAL - ECONOMY MODE:
a) Press the Economy Mode button (Figure 13).
b) Use the (-) or (+) buttons to select the desired
temperature. (Example, Select 18 ºC)
c) The selected temperature is saved.
The existing room temperature will be displayed again
after a few seconds.
Note: This mode is recommended for long absences
from the room and is the ideal temperature for
nighttime.
Recommended temperature: 17 ºC.
•
MANUAL - ANTI-
FREEZING
MODE:
a) Press the Anti-
freezing
Mode button (Figure 13).
b) Use the (-) or (+) buttons to select the desired
temperature. (Example, Select 7 ºC)
c) The selected temperature is saved.
The existing room temperature will be displayed again
after a few seconds.
Note: This mode is recommended for unused
dwellings in extremely cold climates.
Recommended temperature: 5 ºC.
IMPORTANT:
If the selected temperature is higher
than that of the room the heater will start operating
(the flame symbol will be displayed
).
Note:
If, no buttons are pressed after approximately
ten seconds the screen will be switched off.
It will be switched on again when any button is
pressed.
5.6
Switching off
The heater operation can be disconnected by pressing
the “Standby” button (Fig. 13).
The heater can be permanently switched by the
ON/OFF switch at the rear of the unit.
ENGLISH
3
1
Summary of Contents for HE1200
Page 35: ......
