33
OPERATING INSTRUCTIONS
WARNING.
Be sure to tighten the mitre table
lock (25) before making a cut. Failure to do so
could result in the table moving during the cut
and cause serious personal injury.
Bevel lock (B1)
The bevel lock (16) is used to set the blade at the
desired bevel angle.The mitre saw bevel cuts
from 0° to 45° to the left and right.To adjust the
bevel angle loosen the bevel lock and pull out
the 0° bevel adjuster (18). Adjust the saw arm to
the desired bevel angle.
WARNING
.Be sure to tighten the bevel lock (16)
before making a cut. Failure to do so could result
in the saw arm moving during the cut and cause
serious personal injury.
Bevel adjuster
The bevel adjuster (18) needs to be pulled out
before the bevel angle can be adjusted.
To return the saw arm to the vertical (0° bevel)
position move the saw arm to the left and push
in the 0° bevel adjuster (18).
Return the saw arm to the vertical position, it
will automatically stop at the 0° bevel position.
Tighten the bevel lock (16).
Clamp assembly
The clamp assembly (10) can be mounted to the
fence, either side of the saw blade, to suit the
task at hand.
Use the clamp assembly lock (11) at the back
of the fence to secure the clamp assembly in
position.
Spindle lock button
The spindle lock button (26) prevents the blade
in the saw from rotating. Depress and hold the
spindle lock button while installing, changing, or
removing the blade.
Rotating lower blade guard
The rotating lower blade guard (12) provides
protection from both sides of the blade. It ret-
racts over the upper blade guard (9) as the saw
is lowered into the workpiece.
Dust bag
The dust bag (15) fits over the dust extraction
the dust bag when it is no more than half full.
This allows better air flow through the bag.
Attaching the side bars
The side support bars (36) help to support the
material when working with long workpieces.
There are two location holes (37) for a support
bar on either side of the table. Loosen the stop
with a Phillips head screwdriver. Push the
side bars (36) into the position holes (37) and secure
them to prevent them falling out by tightening the
stop screws (38) Ensure the side bars are fully inserted
before using them to support the workpiece.
The locking knob (41) must be tightened to
secure the support bars in position.
Trench depth adjustment (B2)
In its normal position, the trenching stop (31)
permits the saw blade to cut right through a
workpiece.When the saw arm is lifted, the tren-
ching stop can be moved to the right so that the
trenching depth adjustment screw (30) contacts
the stop as the saw arm is lowered.This restricts
the cut to a “trench“ in the workpiece.The depth
of the trench can be adjusted with the trenching
depth adjustment screw (30) and locked in posi-
tion with the trenching depth lock nut (32).
Insert the plug on the connection lead into a
grounded socket.The green ready indicator (43)
will light up.
1) To turn the saw on depress and hold the on/
off trigger switch (24)
2) To turn the saw off release the on/off trigger
switch (24).
Turning on the laser line generator (B3)
The laser line generator emits 2 intense narrow
beams of pure red light to guide you as you
cut. It improves operator cutting vision, enables
faster set-up, increases accuracy and improves
safety.To turn on the laser lines press the combi-
nation switch (2).To turn off the laser press the
EN
screws (38)
