34
OPERATING INSTRUCTIONS
combination switch (2) one more time.
Working light (B3)
There is an LED to light the working area on the
bottom of the operating handle (7).
Press the combination switch (2) twice to turn
on the working light.
Press the combination switch (2) three times to
turn on the laser light and the working light.
Press the combination switch (2) four times to
turn off the switch laser light and the working
light.
Setting the table square with the blade
1) Make sure that the electrical plug is removed
from the power point.
2) Push the saw arm (5) down to its lowest
position and engage the release knob (6) to
hold the saw arm in the transport position.
3) Loosen the mitre lock (25) and press the
locking button (25A).
4) Rotate the table (21) until the pointer is
positioned at 0º.
5) Tighten the mitre lock (25).
6) Loosen the bevel lock (16) and set the saw
arm (5) at 0º bevel (the blade at 90º to the
mitre table).Tighten the bevel lock (16).
7) Place a set square against the table (21) and
the flat part of the blade.
NOTE
. Make sure that the square contacts the
flat part of the saw blade, not the teeth.
8) Rotate the blade by hand and check the
blade-to-table alignment at several points.
9) The edge of the set square and the saw blade
should be parallel.
10) If the saw blade angles away from the set
square, adjust as follows.
11) Use a 13mm wrench or adjustable wrench
to loosen the lock nut securing the 0° bevel
adjustment screw (35). Also, loosen the bevel
lock (16).
12) Adjust the 0° bevel adjustment screw (35)
with a 4mm hex key (not supplied) to bring
the saw blade into alignment with the square.
13) Loosen the 2 Phillips head screws holding
the pointer of the bevel scale (17) and adjust
the position of the pointer so that it accu-
rately indicates zero on the scale. Retighten
the screw.
14) Retighten the bevel lock (16) and the lock
nut securing the 0° bevel adjustment screw
(35).
NOTE.
The above procedure can also be used
to check the angle of the saw blade to the table
at either 45º bevel angle to the left or to the
right.The 45° bevel adjustment screws (33 & 34)
are on opposite sides of the saw arm.You will
require a 13mm wrench or adjustable wrench
(not supplied) for the lock nut and the 6mm hex
key (not supplied) for the set screws.
Setting the fence square with the table
1) Make sure that the electrical plug is removed
from the power point.
2) Push the saw arm (5) down to its lowest positi-
on and engage the release knob (6) to hold
the saw arm in the transport position.
3) Loosen the mitre lock (25).
4) Rotate the table (21) until the pointer is posi-
tioned at 0º.
5) Tighten the mitre lock (25).
6) Using the 5mm hex key (20) loosen the screws
which secure the top sections (19A + 19B) of
the fence and remove these top sections.
7) Using the 5mm hex key, loosen the four
screws securing the fence (19) to the
base.
8) Place a square against the fence (19) and
alongside the blade.
9) Adjust the fence (19) until it is square with the
blade.
10) Tighten the screws securing the fence (19).
11) Loosen the Phillips head screw holding the
pointer (22) and adjust it so that
it accurately indicates the zero position
on the mitre scale.
12) Retighten the screw securing the mitre scale
pointer (22).
EN
mitre scale
