Haulotte STAR 10, Maintenance Book

Page: 99 / 166

99 4000414930 E 10.15 USA / GB
Chassis and turntable
Replacing the wheel pivot
MS0047
Chassis and turntable
Replacing the wheel pivot
1 - You will need
2 - Level of knowledge required
It is important that the person performing the work on the machine knows all the relative safety information contained
in the instruction manual.
3 - Safety instructions
• PPE (Personal Protective Equipment: glove, safety shoe,
glasses, etc…)
• Standard tool kit
• Strap (Capacity : 500 kg / 1100 lb)
• Bridge crane 1000 kg(2200 lb) (minimum)
• Torque wrench (10 Nm - 115 Nm)
• Wrench and sockets up to diameter 36 mm
• Mounting punches (50 - 70 mm)
• Grease
• Place barriers around the perimeter of the work area
Exclusively use tools and auxiliary average adapted. Always wear necessary safety clothing. This procedure is to be carried out after the
first 50 hours and then every 250 hours.
Only an authorized and qualified technician can work on HAULOTTE® machines.
• The technician should take all steps to protect themselves or others against all risks of injury related to
this intervention.
• The technician should ensure they have the PPE (personal protective equipment) suitable for the job and
the particular conditions of environment in witch the material can be found (see safety information
specific to the operation site).
• Position the machine on a flat ground, stabilized and in a released environment.
• Mark out the work area.
• Cut the contact, to remove the key, open the battery cut if fitted.
• Place a "DO NOT USE" decal near the start/stop contactor (key switch) to inform personnel that
interventions are currently underway on the equipment.
• The pressure in the hydraulic system is very important. It can cause accidents. Relieve the pressure
before any intervention and never search for oil leaks using your hands.
• Attention to the risks of burns, the hydraulic system works at high temperatures.
• The exhaust fumes of the engines contain harmful products of combustion. Only start and run the engine
in a well ventilated Area. In a closed room, you must use a suitable system to evacuate the exhaust to
the outside.