Haulotte HT132RTJ PRO, Maintenance Book

Page: 84 / 144

84 4000392130 E03.16 USA / GB
Control-Lubrication
Cables
E016
To access parts :
• Place the machine on flat and firm ground.
• Remove the protection covers and/or inspection flaps.
• Power up the machine and select the console located on the turntable.
• Raise the boom to horizontal (For machines fitted with)
• Check that the attachment device for the cables is in place and tight at all visible attachment points.
• Extend the structure to gain access to the cables :
• Extend the boom at least 3 m(9 ft10 in) for telescopic machines.
• Raise the mast assembly up to the inspection flaps.
Using a flash light, perform a visual inspection of the following items :
• Check that cables are properly aligned with one another.
• Check that the cables under are equal tension.
• Check that the pulleys are properly aligned with the cables.
• Check that the cable is properly seated in the pulley.
• Check that nothing blocks the chain guides.
• Check the condition of the cables. If any of the following defects are observed, replace the pair of cables.
• The maximum reduction in diameter from the original diameter must not exceed 1 mm.
Machine Original diameter
STAR 6 - 8 - 10 3 mm
H21TX - H23TPX - H25TPX 9 mm
HT43RTJ PRO 19 mm