Haulotte Group star 13, Operator'S Manual

Page: 72 / 104

72 4000426500 E 02.16 USA / GB
STAR 6 - STAR 13
D
- Operation instructions
A buzzer beeps in the following conditions :
• Overload (if fitted).
• Machine out of stowed position and on a slope greater than allowable slope.
• Hydraulic oil overheating.
• Movements option.
• Indicators / Cluster : All indicators are checked after powering on the machine
1.3 - OPERATION FROM THE PLATFORM CONTROL BOX
• The platform control box can only be used if :
• The E-stop buttons on both ground and platform control boxes are not pressed in.
• Machine switched on at ground control box.
• Platform control box selected from ground control box.
• A faulty joystick is not taken into account to control a movement. If this fault disappears, the
movement is authorised again.
• An E-Stop button is present at each control box. When pushed in, it stops all functions movements
and will shut off the engine (if equipped).
• An enable switch ( 123 ) is present that should be activated and maintained to authorize one or more
movements. If the enable switch is kept active for more than 8 seconds without selecting a function
movement, then movement is disallowed. The enable switch must be released before movement can
occur.
• The release of "Enable switch" ( 123 ) while performing a movement stops all the movements. The
stop of movements is progressive. If the "Enable switch" is pressed again quickly within 0,5 s the
movement restarts. If the "Enable switch" is not pressed again quickly enough within + 0,5 s the
movement will not restart. It could restart only when the selected function switch/joystick is released
to neutral position.
• All switches and joystick operating a movement, return automatically to neutral when released.
• At power up, a switch in it's neutral position will be taken into account to authorize movement.
• The status of the switches is tested automatically when the machine is switched on, and checked at
every starting. A switch or joystick will be active only after it has been detected in neutral position.
A buzzer beeps in the following conditions :
• Overload (if fitted).
• Machine out of stowed position and on a slope greater than allowable slope.
• Indicators - All the indicators are tested
• When the machine is switched on.