A
B
C
D
E
F
G
H
I
107
24203 3237 0
E 06 10
EN
F
- Special procedure
Engine-powered articulated lifts, 12 - 26 m
4 - Loading and unloading
N.B.-:-W
HEN
CLIMBING
,
DURING
LOADING
OR
UNLOADING
HAULOTTE®
RECOMMENDS
POSITIONING
THE
COUNTERWEIGHT
AT
THE
REAR
.
Section F 4.2 Putting in transport position.
4.1 - PRINCIPLE
As the slope of the ramp is usually greater than the authorised slope for driving, the arm and
boom must be lowered to enable driving to take place.
In this case, the buzzer is not activated but driving is authorised.
4.2 - PUTTING IN TRANSPORT POSITION
The machine must be completely stowed.
1.
Check the absence of load in the platform.
2.
Depending on the configuration of the machine, lift the arm and boom slightly, extend boom sli-
ghtly the telescope then push transport position selector ( 13 ) to the right.
3.
Secure the machine to the anchorage points provided for this purpose.
4.
Block the turntable with the rotation stop pin located under the turntable.
Lift the platform again to avoid contact with the ground.
To avoid any risk of tipping over, the boom must be maintained in the axis of the chassis.
To avoid any risk of sliding during loading, ensure that :
• The loading ramps can bear the load.
• The loading ramps are correctly attached.
• The loading ramp has sufficient grip.
To climb the slope, select low driving speed
.
If the slope is too steep, use a winch in addition to traction.
Never place yourself below or too close to the machines during loading.
A wrong move can lead to the tipping over of the machine and cause serious bodily and material accidents.
Do not transport the machine if the turntable is not blocked.
