Haulotte Group H14T, Operating And Maintenance Instructions Manual, Page: 51 / 78

Operating and maintenance instructions - H14TX - HA16TPX
37
Caution!
Caution!
4.2.2 - Checks before using the machine
4.2.2.1 -Operation zone
• Ensure that the machine is on flat, stable and sufficiently resistant
ground (see section 2.4 - floor pressure)
See table of characteristics for
maximum authorised slopes.
• Ensure that no obtables can obstruct machine movement:
- travel (machine movement)
- turntable rotation
- telescoping and lifting: see "Working area" diagram.
4.2.2.2 -General appearance
Photo 6: Rotation pin
• Ensure that the pin blocking turntable rotation (rep. 1, Photo: Rotation
pin, page 37) has been removed.
• Visually inspect the whole machine: pay particular attention to paint
chips or battery acid leaks.
• Check that there are no loose bolts, nuts, connections or hoses, no oil
leaks, no cut or disconnected electric conductors.
• Check the boom and platform: no visible damage, no signs of wear or
deformation.
• Check that there no leaks, no signs of wear, impacts, scratches, rust
or foreign matter on the cylinder rods.
• Check that there are no leaks on the wheel reducers.
• Pump and hydraulic station; no leaks, components tight.
• Check that the wheel reducers are not disconnected.
• Check the tightness of wheel nuts and the degree of tyre wear.
These machines are not insulated
and must not be used near electric
lines.
4.2.2.3 -Electricity
• Check that the battery terminals are clean and tight: loose or corroded
terminals may result in loss of power.
• Respect battery manufacturer’s safety instructions.
• Check that the platform control panel power cable is in good condi-
tion.
• Check that the emergency stop devices are working properly.
• Check that the tilt detector works properly (ref.19 , Photo: "Turntable"
control panel, page 35) by tilting the support plate. Beyond the maxi-
mum value, an alarm should sound if the machine is unfolded.
1