Form No. UGMW1M-0307
5
INSTALLATION
Figure 5. Assembly of Breath Protectors
ASSEMBLY OF BREATH PROTECTORS
Breath protectors are standard equipment on the
UGMW-1. Refer to Figure 5 and follow these steps
for installation.
1. Remove protective paper from the three breath
protectors.
2. To install a side, loosen and remove the four
screws from underside of the top housing. Slide
mounting bracket into position with studs facing
downward. Re-install and tighten the four screws
to secure the mounting bracket to the top
housing.
3. Align breath protector mounting holes with studs
and secure using acorn nuts provided. Do not
over-tighten.
4. Repeat Steps 2 and 3 to complete installation on
the remaining breath protectors.
5. Insert a corner trim bracket through the holes
from the top side of each breath protector corner.
Secure using washers and acorn nuts provided.
Do not over-tighten.
Note: Cleanability codes require a gap of 1/16" to
1/8" between the breath protectors at the corners.
Clean gaps using a soft, clean and damp cloth. Do
not use glass cleaner and/or paper towel. Glass
cleaner may scratch the surfaces.
Screw
Breath Protector
Mounting Bracket
Acorn Nuts
Top Housing