Form No. UGMW1M-0307
7
MAINTENANCE
CLEANING
Hatco Merchandising Warmer units are designed for
maximum durability and performance, with minimum
maintenance.
WARNING
To avoid any injury turn the power OFF to the
unit and allow to cool before performing any
maintenance.
WARNING
Units are not waterproof. DO NOT submerge in
water. Do not operate if unit has been
submerged in water.
WARNING
To avoid electrical shock or personal injury, do
not steam clean or use excessive water on the
unit.
To preserve the finish of the Ultra-Glo™
Merchandising Warmer, it is recommended that the
metal surfaces be wiped daily with a clean, soft,
damp cloth. Stubborn stains maybe removed with a
good stainless steel cleaner or a non-abrasive
cleaner. Hard to reach areas should be cleaned with
a small brush and mild soap.
NOTICE
Wipe off breath protectors using a soft, clean
and damp cloth. Do not use glass cleaner and/or
paper towel. Glass cleaner may scratch the
surfaces.
NOTICE
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your unit
marring its appearance and making it
susceptible to dirt accumulation.
DISPLAY LIGHT BULB REPLACEMENT
The display light is an incandescent bulb which
illuminates the warming area. This bulb has a
special coating to guard against injury and food
contamination in the event of breakage.
To replace a bulb, disconnect the power supply and
wait until the unit has cooled. Display lamps have a
threaded base. Unscrew the bulb from the unit and
replace it with a new specially coated incandescent
bulb. Hatco shatter-resistant bulbs meet NSF
standards for food holding and display areas.
NOTE: Hatco shatter-resistant light bulbs meet NSF
standards for food holding and display areas. For
120 Volt applications, use Hatco part number
02.30.043.00.
WARNING
Only light bulbs which meet or exceed NSF
standards, specially designed for food holding
areas may be used. Breakage of light bulbs not
specially coated could result in personal injury
and/or food contamination.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966, or International
fax 414-671-3976.
WARNING
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Replacement Parts when service
is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
