INSTALLATION
Form No. UGAM-0908
15
4. Align the other stand with the mounting holes at
the opposite end of the unit and secure the
stand to the unit using the screws supplied.
5. If applicable, route the flexible conduit through
the 1″ diameter hole cut into the mounting
surface.
6. Secure the stands to the mounting surface.
NOTE: Two pairs of stands will be needed for
mounting dual units.
Figure 15. Tubular Stand Mounting
Mounting
Screw
Flexible
Conduit
Tubular
Stand
Permanent Surface Mount
Tubular stand mounting permanently attaches the
unit to a countertop or serving table. All wiring may be
concealed within one of the tubular stands.
To ensure safe and proper operation, refer to the
“Minimum Clearance Requirements” listed in
the INSTALLATION section of this manual.
The aluminum, non adjustable tubular stands are
available in one inch (25 mm) increments from
14″–24″ (356–610 mm).
NOTE: Tubular stands are not field retrofittable.
NOTE: If wiring is to be concealed, a 1″ (25 mm)
diameter hole must be provided in the
mounting surface centered under the stand
containing the wiring conduit.
Figure 14. Countertop Conduit Hole Dimension
1. Position the unit upside-down on a flat surface.
NOTE: Units for this application are supplied with
the conduit attached to one side of the unit.
Conduit should not be removed.
2. If applicable, route the flexible conduit through
the center of one of the stands (see Figure 15).
3. Pull the conduit-side stand up against the unit
and secure the stand to the unit using the
screws supplied.
1-3/16″
(30 mm)
Distance from end of unit to center of conduit hole.
Needed for 1″ diameter hole cutout in mounting surface.
CAUTION