INSTALLATION
14
Form No. UGAM-0908
Assembly
Ultra-Glo
®
Strip Heaters are shipped with most
components pre-assembled. Dual units come with a
required 3″ (76 mm) or 6″ (152 mm) spacer pre-
assembled at the factory.
Optional mounting equipment and remote control
enclosures must be installed on location.
Undershelf Mounting
Undershelf mounting permanently attaches the unit
to the underside of a shelf. It can be mounted to a
flat shelf or a shelf with rolled/flanged edges using
the included adjustable angle brackets. A minimum
gap of 1″ (25 mm) is required between the unit and
the underside of the shelf to prevent heat damage to
the electrical system of the unit.
To ensure safe and proper operation, refer to the
“Minimum Clearance Requirements” listed in
the INSTALLATION section of this manual.
NOTE: When mounting the unit under a shelf, it is
recommended to use a remote control
enclosure.
If the shelf has a rolled or flanged edge, use the
appropriate screw hole locations on the adjustable
angle brackets to mount the unit below the lowest
edge of the rolled or flanged shelf. The adjustable
angle brackets can provide a 1″ (25 mm),
1.5″ (38 mm), or 2″ (51 mm) gap between the unit
and the underside of the shelf.
DO NOT conceal unit. Unit must be installed
below the lowest edge of a rolled or flanged
shelf. Failure to mount unit properly may result
in premature failure of switches and void the
product warranty.
Figure 11. Flanged Shelf Installation
1″ (25 mm)
Gap
Minimum
Shelf with 3/4″ (19 mm)
flanged edge
Adjustable
Angle
Bracket
Unit below
lowest edge of
flanged shelf.
NOTICE
CAUTION
Adjustable Angle Bracket Mounting
1. Position the unit on a flat surface with the
heating elements facing down.
2. Remove the two middle screws from each end
of the unit.
3. Align the appropriate holes on an adjustable
angle bracket with the middle screw holes on
one end of the unit. Secure the angle bracket
using the removed middle screws.
4. Repeat step 3 for the opposite end of the unit.
Figure 12. Adjustable Angle Bracket Installation
5. Fasten the angle brackets to the underside of
the shelf using appropriate fasteners (not
supplied by Hatco).
NOTE: Two pairs of brackets will be needed for
dual units.
Figure 13. Dual Unit Mounting
Two adjustable
angle brackets
on each end
for dual units.
Adjustable
Angle Bracket
Middle
Screws
