IMPORTANT SAFETY INFORMATION
Form No. HBGM-0608
1
ELECTRIC SHOCK HAZARD:
• Plug unit into a properly grounded electrical
outlet of the correct voltage, size, and plug
configuration. If the plug and receptacle do
not match, contact a qualified electrician to
determine and install the proper voltage and
size electrical outlet.
• Turn the power switch OFF, unplug the power
cord, and allow the unit to cool before
performing any maintenance or cleaning.
• DO NOT submerge or saturate with water.
Unit is not waterproof. Do not operate if unit
has been submerged or saturated with water.
• This unit is not “jet-proof” construction. Do
not use jet-clean spray to clean this unit.
• Unit is not weatherproof. Locate the unit
indoors where the ambient air temperature is
a minimum of 70°F (21°C).
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or
worn.
• Do not attempt to repair or replace a
damaged power cord. The cord must be
replaced by Hatco, an Authorized Hatco
Service Agent, or a person with similar
qualifications.
• Use only Genuine Hatco Replacement Parts
when service is required. Failure to use
Genuine Hatco Replacement Parts will void
all warranties and may subject operators of
the
equipment
to
hazardous
electrical
voltage, resulting in electrical shock or burn.
Genuine
Hatco
Replacement
Parts
are
specified
to
operate
safely
in
the
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment.
FIRE HAZARD: Locate the unit a minimum of
1″ (25 mm) from combustible walls and
materials. If safe distances are not maintained,
combustion or discoloration could occur.
This unit has no “user-serviceable” parts and
must be serviced by qualified personnel only. If
service is required on this unit, contact an
Authorized Hatco Service Agent or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966; or International
fax 414-671-3976.
WARNING
BURN HAZARD: Some exterior surfaces on the
unit will get hot. Use caution when touching
these areas.
Locate the unit at the proper counter height in
an area that is convenient for use. The location
should be level to prevent the unit or its
contents from falling accidentally and strong
enough to support the weight of the unit and
contents.
Do not operate built-in models without the
control box mounted properly as described in
the installation instructions.
This unit is recommended for use in metallic
countertops.
Damage
to
non-metallic
countertop material caused by heat generated
from Hatco equipment is not covered under the
Hatco warranty. For other surfaces, verify that
the material is suitable for temperatures up to
200°F (93°C).
Built-in units must not have a setpoint
temperature
higher
than
200°F
(93°C).
Temperatures exceeding 200°F (93°C) will
damage the unit and void the warranty.
Do not lay unit on the side with the control panel
or damage to the unit could occur.
Do not slide pans across glass surface, use
rough-bottomed pans, or drop anything on
glass surface. Scratching or breakage may
occur. Damage to glass surface or breakage of
glass caused by misuse is not covered under
warranty.
CAUTION
NOTICE
Read the following important safety information to avoid serious injury or death and to
avoid damage to equipment or property.
All manuals and user guides at all-guides.com
