Form No. GRSM-0705
16
MAINTENANCE
ACCESSORIES
4" (102 MM) ADJUSTABLE LEGS
(GRS MODELS)
NOTE: 4" (102 mm) legs are standard on models
42" (1067 mm) and wider.
Carefully lay unit on its side. Install legs to bottom of
unit as shown in Figure 10. Hand tighten legs until
snug. Do not overtighten. Return unit to the upright
position.
WARNING
Do not lay unit on the side with the control panel
or damage to unit could occur.
NOTE: Legs are adjustable for leveling the unit. Use
a 9/16" (14 mm) open-end wrench to make leveling
adjustments once the unit is placed in final position.
Leg Adjustment
Adjust leg using
a 9/16"(14 mm)
open-end wrench
and turning bottom
of leg accordingly.
Figure 10. Leg Installation
CLEANING
The Hatco Glo-Ray Heated Shelf units are designed
for maximum durability and performance, with
minimum maintenance.
WARNING
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool before performing any maintenance.
WARNING
The Glo-Ray Heated Shelf is not waterproof. To
avoid any injury or damage to the unit DO NOT
submerge or saturate with water. Do not operate
if it has been submerged or saturated with water.
To preserve the finish of the Glo-Ray Heated Shelf,
it is recommended that the surfaces be wiped daily
with a damp cloth. Stubborn stains may be removed
with a good stainless steel cleaner or a non-
abrasive cleaner. Hard to reach areas should be
cleaned with a small brush and mild soap.
CAUTION
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your Glo-
Ray Heated Shelf marring its appearance and
making it susceptible to soil accumulation.
WARNING
If service is required on this unit, contact your
Authorized Hatco Service Agent, or contact the
Hatco Service Department at 800-558-0607 or
414-671-6350; fax 800-690-2966 or International
fax 414-671-3976.
WARNING
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Replacement Parts when service
is required.
WARNING
Genuine Hatco Replacement Parts are specified
to operate safely in the environments in which
they are used. Some aftermarket or generic
replacement parts do not have the
characteristics that will allow them to operate
safely in Hatco equipment. It is essential to use
Hatco Replacement Parts when repairing Hatco
equipment. Failure to use Hatco Replacement
Parts may subject operators of the equipment to
hazardous electrical voltage, resulting in
electrical shock or burn.
