Form No. GRSM-0705
1
IMPORTANT SAFETY INFORMATION
WARNINGS
To avoid any injury, turn the power switch
OFF, unplug the unit from the power source
and allow to cool before performing any
maintenance or cleaning.
The Glo-Ray Heated Shelf is not waterproof.
To avoid any injury or damage to the unit DO
NOT submerge or saturate with water. Do not
operate if it has been submerged or saturated
with water.
Plug unit into a properly grounded electrical
outlet of the correct voltage, size and plug
configuration. If the plug and receptacle do
not match, contact a qualified electrician to
determine the proper voltage and size and
install the proper electrical outlet.
To avoid any injury or damage to the unit do
not pull unit by power cord.
To prevent any injury, discontinue use if
power cord is frayed or worn.
Do not lay unit on the side with the control
panel or damage to the unit could occur.
For safe and proper operation, the unit must
be located a reasonable distance from
combustible walls and materials. If safe
distances are not maintained, discoloration
or combustion could occur.
If service is required on this unit, contact
your Authorized Hatco Service Agent, or
contact the Hatco Service Department at
800-558-0607 or 414-671-6350; fax 800-690-
2966 or International fax 414-671-3976.
This product has no “user” serviceable parts.
To avoid damage to the unit or injury to
personnel, use only Authorized Hatco
Service Agents and Genuine Hatco
Replacement Parts when service is required.
Genuine Hatco Replacement Parts are
specified to operate safely in the
environments in which they are used. Some
aftermarket or generic replacement parts do
not have the characteristics that will allow
them to operate safely in Hatco equipment. It
is essential to use Hatco Replacement Parts
when repairing Hatco equipment. Failure to
use Hatco Replacement Parts may subject
operators of the equipment to hazardous
electrical voltage, resulting in electrical
shock or burn.
CAUTIONS
Unit is not weatherproof. For safe and proper
operation locate the unit indoors where the
ambient air temperature is a minimum of 70°F
(21°C).
To avoid any injury or damage locate the unit
at the proper counter height, in an area that is
convenient for use. The location should be
level to prevent the shelf or its contents from
accidentally falling, and strong enough to
support the weight of the unit and food.
Some exterior surfaces on the unit will get
hot. Use caution when touching these areas
to avoid injury.
The National Sanitation Foundation (NSF)
requires that GRS Series units over 36"
(914 mm) in length or weighing more than
80 lbs. (36 kg) to be either sealed or raised on
the installation surface. If this unit cannot be
sealed at the point of use, 4" (102 mm) legs
are included to allow for proper cleaning
access below unit. See ACCESSORIES for
installation instructions.
CAUTIONS
Damage to non-metallic countertop material
caused by heat generated from Hatco
equipment is not covered under the Hatco
warranty. Recommended for use in metallic
counters. For other surfaces, verify that the
material is suitable for temperature up to
180°F (82°C).
Use of excessive force when tightening
mounting screws may damage unit or
countertop (GRSB & GRSBF units).
Use only non-abrasive cleaners. Abrasive
cleaners could scratch the finish of your Glo-
Ray Heated Shelf marring its appearance and
making it susceptible to soil accumulation.
IMPORTANT! Read the following important safety instructions to avoid personal injury or
death, and to avoid damage to the equipment or property.
