Hatco Glo-Ray GR2SDH-24, Installation And Operating Manual

Page: 20 / 24

WARNINGS
To avoid any injury, turn the power switch OFF,
unplug the unit from the power source and allow
to cool completely before performing any
maintenance or cleaning.
WARNINGS
This product has no “user” serviceable parts. To
avoid damage to the unit or injury to personnel,
use only Authorized Hatco Service Agents and
Genuine Hatco Parts when service is required.
SYMPTOM PROBABLE CAUSE CORRECTIVE ACTION
Light bulb not working. Light bulb defective.
Power turned OFF.
Replace light bulb.
Turn unit ON.
Food cavity not hot enough. Temperature control set too low.
Heating element(s) not working.
Temperature control not working
properly.
Excessive air movement around
unit.
Adjust temperature control to a
higher setting.
Contact Authorized Service
Agent or Hatco for assistance.
Contact Authorized Service
Agent or Hatco for assistance.
Restrict or redirect air movement
(i.e. air conditioning duct or
exhaust fan) away from unit or
install flip-up doors on unit to
contain heat and block air flow.
Food cavity too hot. Temperature control set too high.
Temperature control not working
properly.
Adjust temperature control to a
lower setting.
Contact Authorized Service
Agent or Hatco for assistance.
No heat, but light works. Temperature control set too low.
Heating element(s) not working.
Temperature control not working
properly.
Adjust temperature control to a
higher setting.
Contact Authorized Service
Agent or Hatco for assistance.
Contact Authorized Service
Agent or Hatco for assistance.
No heat and no light. Unit turned OFF.
Circuit breaker tripped.
Turn unit ON.
Reset circuit breaker. If circuit
breaker continues to trip contact
Authorized Service Agent or
Hatco for assistance.
Form No. GR2SDM-0707
18
TROUBLESHOOTING