Form No. GR2SDM-0707
15
ACCESSORIES
LED TEMPERATURE CONTROL
Models GR2SDH and GR2SDS can be equipped
with an LED temperature control device which
regulates the base temperatures and also indicates
the current base temperatures.
NOTE: This option is factory installed only, not
available for retrofit.
NOTE: Units with the LED temperature control do
not have an additional separate base thermostats.
All temperature regulation is performed by the
controller.
NOTE: Units with LED temperature controls
manufactured for use outside the United States use
devices that indicate temperature in Celsius (°C).
The programming instructions are as follows:
1. To set the temperature, turn the red Mode Switch
counterclockwise to the SP-1 position indicated
on the controller. (See Figure 7.)
2. Adjust the Setpoint Screw to the desired
temperature, then turn the red Mode Switch to
the TEMP position. The surface temperature
range is room temperature to 200°F (93°C).
4" (102 MM)
DESIGNER
LEGS
1. To install, place the unit on its non-control side,
making sure the glass is secure.
2. Place hexbolt through short rubber foot (with bolt
head on recessed foot side) and through metal
Designer
Leg. Align bolt in corner hole on base
and tighten securely. (See Figure 8.)
3. After all the legs are secure, return the unit to its
upright position.
STAINLESS STEEL DIVIDER RODS
Additional stainless steel divider rods are available
to help keep product separate in the channels.
DESIGNER
INSET COLOR PANELS
Choose from warm red, black, gray granite, white
granite, hunter green and navy blue inset panels to
coordinate warmer to your decór.
BREATH PROTECTOR(S)
(Not For Retrofit)
Units can be supplied from the factory with breath
protector(s) on the customer side. To install, follow
these steps. (See Figure 9.)
1. Remove protective paper from acrylic surfaces.
2. Position the acrylic breath protector into the
channel on the warmer with the mounting holes
aligned.
3. Secure the breath protector using the
thumbscrews on the top side and acorn nuts on
the bottom side. Tighten thumbscrews until snug.
Do not overtighten.
TEMP.
F
SP1
SP1
Figure 7. Optional LED Temperature Control
Figure 8. Optional 4" (102 mm)
Designer
Legs
Mode Switch
Setpoint Screw
Figure 9. Breath Protector
Summary of Contents for Glo-Ray GR2SDH-24
Page 21: ...Form No GR2SDM 0707 19 NOTES...
Page 22: ...Form No GR2SDM 0707 20 NOTES...
