102
CONTROL UNIT
11
11-5 REPLACING THE FEEDBACK COIL
1
Turn off the power and remove the Control Unit (See 11-1).
2
Unscrew and remove the controller cover. Once
all (8) screws have been removed, carefully lift
off the cover from the controller.
3
Using and open ended spanner or nut runner,
remove the (4) Hex Nut which secure the coil
assy to the contoller.
The X (left and right) axis volume is on the bottom of the Control Unit.
If the X axis volume does not seem to be working properly and the TEST Mode calibration screen has no effect, the
cause is likely to be a problem with or damage to the gears of the X axis volume.
When replacing the feedback coil, you will need a replacement coil and two heat shrink tubes. You will also need
the following tools and some solder.
- Wrench or screwdriver for tamperproof screws (for M4)
- A 7 millimeter spanner, hexagonal screwdriver, or socket wrench
- An 11-12 millimeter spanner
- Cutters
- Wire stripper
- Soldering iron
- Industrial heat gun
Note: This image has been modified to easy illustration
FIG. 11-5a
FIG. 11-5b
TORX TMPR PRF SEC SCREW (8)
M4x12
Remove Solder Joint
COIL ASSY
Summary of Contents for Sega Transformers Shadows Rising
Page 136: ...PARTS LIST 123 18 2 ASSY BILLBOARD TS 0500UK D 1 2 1...
Page 162: ...PARTS LIST 149 18 20 ASSY INST KIT TS INST TH D 1 3...
Page 169: ...4 of 4...
