CONTROL UNIT
93
11
FIG. 11-2e
6
The wire connected to the volume pot will be reused. Use a tool such as a pair of snips or cutters to remove
the old heatshrink tubes which cover the contacts.
7
Use a soldering iron to melt the solder and separate the wires from the old volume pot. Be very careful when
using a soldering iron.
8
If the exposed conductive wire at the end is less than 5mm, use a tool such as a wire stripper or cutter to cut
the wire insulation back to a workable length. Place new sleeving over the wire before resoldering them to
the pot.
9
Once soldered, cover the bare contacts with the sleeving. If heatshrink is used, apply heat from an
appropriate hot air blower to shrink the sleeving tightly over the contacts.
10
Reassemble the pot to the pot bracket by working in reverse order of these instructions.
Refer to the POT VOLUME ADJUSTMENT section of this manual.
FIG. 11-2d
Summary of Contents for Sega Transformers Shadows Rising
Page 136: ...PARTS LIST 123 18 2 ASSY BILLBOARD TS 0500UK D 1 2 1...
Page 162: ...PARTS LIST 149 18 20 ASSY INST KIT TS INST TH D 1 3...
Page 169: ...4 of 4...