HARVEY Axminster Trade AT220TSM, Manual, Page: 21 / 48

- 19 -
6. Adjustment
Before operation, the machine should be carefully adjusted for best performance.
6.1 Sliding Table ( Fig. 24 & Fig .25)
1. Bring the two fences closely together and adjust them to be coplanar.
(The parallelism of two fences has been adjusted at factory and the deviation should be no
more than 0.1mm)
2. Slide the sliding table and use a dial indicator to measure the parallelism as shown in
Fig.24
3. If the reading is no more than 0.1mm, the parallelism is correct. If not, continue with the next
steps.
4. Loosen secure nuts under sliding table completely and tighten them by hands.
5. Loosen nuts (B), see
Fig.25.
6. Turn the thread rod (C) out or in.
7. Push sliding table to ensure that the block (A) is against the thread rod (C).
8. Repeat step 2 and 3, until the parallelism is correct;
9. Tighten screw (B) and the locking nuts of the sliding table.
Fig.24 Fig.25
6.2 Main Table & Table Insert
The main table should be about 0.1mm lower than sliding table.
1, Using a straightedge and feeler gauge to check if the main table need to be adjusted. If yes,
continue the next steps.
2, There are four bolts supporting the main table on four cabinet corners. Loosen A and B, and
turn bolt (C) for height adjustment
Fig.26.
3, Repeat step 1 until the main table is 0.1mm lower than the sliding table.
4, Secure (A) and (B).
Fig.26 Fig.27
Table Insert:
The table inserts are pre-installed at the factory. The top surface of the insert is level with the
table surface. If any adjustment is necessary, turn the set screws (4PCS) in or out to adjust the
insert, as
Fig.27 .