HARVEY Axminster Trade AT220TSM, Manual, Page: 10 / 48

- 8 -
29. Fit the tooling to the machine to operate in the correct direction of rotation. Avoid injury when
on use of tool carriers and handling tools.
30. Don't misuse, foreseeable misuse includes, e.g. feeding small work-pieces without safety
appliance, mounting of a saw blade on the arbor instead of milling tools and feeding work-pieces
in the same direction as of the running tool (climb cutting).
31. When changing safety-related components, these components must meet the lifetime
standard (T10d according ISO 13849-1) which should be not lower than 20 years.
4.3 Residual Risks
1. Take precautions to reduce the hazard of inhalation of harmful dusts (e.g. wearing a dust
mask).
Information on factors that influence exposure to dust, including:
1) The level of tool and machine maintenance
2) The material being machined
3) The importance of local extraction (capture at source),
4) The proper adjustment of hoods/baffles/chutes
5) The external chips and dust extraction system connected t the machine need to comply with
the parameters stated in this instruction for use.
2. Wear ear protection to prevent hearing loss.
Instructions on factors that influence exposure to noise, including:
1) The correct choice of tools
2) The correct speed selection
3) The tools and machine maintenance
4) The type of material being machined
5) The use of any accessories provided
6) The use of ear protection
3. Always wear safety glasses, also use a face or dust mask if cutting operation is dusty.
4. Protect against the hazard of being cut when handling cutters into the machine or doing
maintenance.
5. Do not try to remove chips while the cutter is running and the shaper unit is not in the rest
position.
6. Do not try to use the machine unless all of the guards and other safety devices necessary for
the particular operation are in good working order.
7. In case of power supply failure, the tool may rotate for more than maximum run-down time.
4.4 Safety Equipment
A push block
(Fig.3)
and A push stick
(Fig.4)
must be used
Fig.3 Fig.4