13
Installation of End of Bale Sensor
The end of bale sensor determines the position of the needles on the baler.
When the needles cycle the sensor communicates this information to the
ISO Communication Module (ICM). This information is used for job records
and will be used by the optional Bale Identification system.
Mount the end of bale sensor bracket (001-4648NA and 001-4648NB) as shown
on the back right of the baler
(opposite of the ladder)
. This bracket will clamp to the diagonal support using the backing plate and supplied
hardware
(5/16” x 1 ½” hex bolt with flat washer, lock washer, and nut). There is no exact placement, the
sensor just needs to
see the needle arm when in the home position. Adjust sensor in or out so that it is about
¼” away from the needle arm and tighten both nuts. Be sure it is not making contact, causing damage, or not
too far away from the needle arm, preventing it from reading.
Run the sensor cable (006-7401) and extension (006-7401BBEXT) up to main harness (006-765B2) and
attach to EOB plug.