Propeller Owner’s Manual
139
INSTALLATION AND REMOVAL
61-00-39
Page 3-53
Rev. 17 Apr/20
(28) Install the rod end cap onto the threaded end of the push
rod spool.
NOTE: Make sure the rod end cap is bottomed on the
end of the push rod spool.
(a) Apply Loctite
®
272 to the set screw threads.
(b) Tighten the set screw.
(29) Apply Loctite
®
272 to the push rod threads where the
check nut will be located on the push rod spool next to
the bushing.
(30) Tighten the check nut against the bushing to torque
indicated in Table 3-2.
(31) Attach engine mounted beta system control hardware
to rod end fitting and adjust per airframe or engine
manufacturer’s instructions.
(32) Install the beta light switch against the pin per airframe
manufacturer’s instructions.
(33) Install the spacer and self-locking nut onto the front
of the rod that protrudes through the front of the pitch
change rod and piston.
(a) Follow the airframe manufacturer’s instructions for
making pitch control adjustments.
(34) If the propeller is equipped with an ice protection
system that uses components supplied by Hartzell
Propeller Inc., refer to
Hartzell Propeller Inc. Propeller
Ice Protection System Manual 180 (30-61-80) for
applicable instructions and technical information.
(35) Propeller ice protection system components not
supplied by Hartzell Propeller Inc. are controlled by the
applicable TC or STC holder’s Instructions for Continued
Airworthiness (ICA).
