©Hartenberger Unterwassertechnische Geräte GmbH Rights reserved for technical changes. Issue 01.2011
11
Instructions for use Hartenberger High-Tech-UW-Lamp nano compact
POWER PACK
REMOVING THE CELL PACK
After removing the rear housing cover (see page 10), the complete cell pack can
be unplugged and removed (Fig. 6).
The 3 pins serve as the mechanical and electrical connection between the cell
pack electronics and the housing electronics.
There is stowage for a spare housing O Ring (48 x 1,6 50° hardness) located in
the rear housing cover (adjacent to the plastic cover).
FITTING THE CELL PACK
Hold the rear housing cover upwards and carefully plug the cell pack onto the
rear housing cover. Ensure that the 3 plugs on the rear housing cover are guided
into the sockets carefully. The plug arrangement prevents incorrect connection.
Push the cell pack fully down on to the pins without damaging/distorting the pins
and without use of excessive force.
PREPARATION FOR USE
BEFORE THE LAMP IS USED FOR THE FIRST TIME
Before the first use, the cells must be charged. Hartenberger underwater lamps
are manufactured to a high degree of precision and each lamp is tested to a
water pressure of 10 bars. The condition of the lamp and in particular the housing
and sealing rings should however be checked before the first use (see page 8).
Warning !
Due to damage during transportation or hidden material defects, leakage
can occur (not the fault of the manufacturer). To check if the housing is
pressure tight, the first dive should be carried out without the housing
insert, i.e. empty.
Fig. 6: Removal of the power pack
!
