Install Sockets
PAGE 9
NET FITTING AND TENSIONING.
CLP050 - P-CLIP
(HKS029)
CLP050
FPK362 -
P-clip
Net clip
BOL331 (ALREADY IN PLACE)
17: Thread the head line rope through the top eyelet at the top of the
centre hinge upright FEP164 and then thread it through the clamcleat
as shown to the left.
Thread the head line rope through ASY130 (plastic hand grip) and tie a
knot in the end.
SEP252 -
PART OF FEP029
SEP251 -
PART OF FEP029
BOL607
M6x40mm PAN HEAD SCREW
BOL665
M6x17mm JOINT CONNECTOR
18: Thread the bottom of the net in and out of the net retaining bars as shown above, then attach
the net bar to the back/side board using the bolt shown. Once you have connected the net bars
tighten the roof of the net by using the handle shown to the left of section 17.
tt is very important to remember to release the net as shown on the label attach to the
upright before folding.
Note:
16: O
nce you have un-rolled the net, find
the label with crossbar on it. Find the
centre of the net and attach it to the
crossbar using the net clips found in
FPK362. Find either the top left/right
hand corner. Thread the net through the
p-clip (CLP050), and using the bolt
BOL331 you can attach it to the bracket
as shown on the left. Then using the net
clips from FPK362 clip the net up every
five to six mesh squares, on the
crossbar and uprights.
NET RETAINING CLIPS
FPK362
Before Fitting the Net
- Make sure two or more people stretch the Net out into
shape as much as possible. Due to the stiffness of the material, it may seem to
be too tight. By stretching the Net into it’s Box shape will allow easier assembly.
Tip
