1-2
888-2595-001
12/20/11
WARNING: Disconnect primary power prior to servicing.
Section 1 Introduction
ZX Series
•
Section 3
: Operation, describes operation of the equipment and is intended to be the
primary section referenced by operating personnel.
•
Section 4
: Theory of Operation, is included to help service personnel to understand
the inner workings of the transmitter.
•
Section 5:
Maintenance, lists and explains alignments and adjustments that could be
required to maintain the transmitter once in operation.
•
Section 6:
Troubleshooting, is included as a servicing aid to be used along with Sec-
tions 4 and 5 by qualified service personnel to identify and correct an equipment mal-
function.
•
Section 7:
Parts List, is a comprehensive listing of the components that may be
replaced in the field.
•
Appendix A:
FM WEB remote option, proivdes information about the optional
WEB remote interface card.
1.2
Features / Benefits
The Harris ZX Series of transmitters offers the following useful features and benefits:
•
HD Radio capable with on-the-fly switching between FM, FM+HD, or HD mode
when used with FlexStar exciter.
•
Broadband design to eliminate tuning adjustments from 87.5 MHz through 108 MHz
(N+1 capable). Frequency change can be done electronically in seconds with Micro-
Max or FlexStar exciter or Digit exciter with external controller.
•
Redundant hot-plug RF amplifier modules allow module replacement while transmit-
ter is in operation.
•
Redundant hot-plug power supplies modules allow module replacement while trans-
mitter is in operation, including transmitter logic supplies. (each PS module has both
50V and 5V logic supplies)
•
Redundant cooling fans allow transmitter to operate at full power for extended peri-
ods with a fan failure, while fan tachometer alarm notifies service personnel of fail-
ure condition.
•
Three independent AC mains inputs per amplifier chassis and regulated power sup-
plies allow transmitter to accept a wide range of single or three phase mains power
without concern for line balance or rotation.
•
Redundant IPA amplifiers and PA splitters eliminate a single point of failure.
•
Non software-based controller for simple, repeatable operation. Does not require
UPS or battery to retain settings during AC mains failures.
•
EIA rack mounting for easy installation with only 16RU height for 5000W amplifier.
Summary of Contents for ZX2500
