Harrington Network Plus HS-3030, Programming Manual, Page: 10 / 65

HS-3030 Programming Manual
4
If there is a break in a
communications link (see
Figure
2 ) the broadcast will be disposed
of by the unit unable to pass it on.
In the situation where a unit has
been removed from the loop (see
Figure 3 ), the broadcast will be
passed only from com2 to com1 at
the jump. In
Figure 3 , panel 5 will
pass the broadcast to panel 3, but
panel 3 will not pass the broadcast
on to panel 5 since it is supposed
to be communicating to panel 4.
1.3 Addressable Devices
The HS-3030 can use analog/addressable devices. There are two general types of devices:
sensors and modules. The following devices are supported:
Modules
M500M Monitor module
M501M Mini monitor module
M502M Monitor module for conventional 2-wire smoke detectors
M503M Micro monitor module (EN54 listed only)
M500DM Dual monitor module
M500R Relay module
M500S Control module
M500X Isolator module
IM-10 Intelligent Input Monitor Module
CZ-6 Zone Interface Module
CR-6 Relay Control Module
SC-6 Supervised Control Module
Sensors
1251B Ionization type smoke detector, low profile
1551 Ionization type smoke detector
2251B Photoelectric type smoke detector, low profile
2551 Photoelectric type smoke detector
2251TB Photoelectric type smoke detector c/w heat detector, low profile
2551TH Photoelectric type smoke detector c/w heat detector
5251 Fixed temperature detector, low profile
5251H Fixed temperature, high temperature
5551 Fixed temperature detector
5251R Rate of Rise and fixed temperature detector, low profile
5251B Low Profile Intelligent Plug-in Thermal Sensor
5251RB Intelligent Plug-In Thermal Sensor
5251H Low Profile Intelligent Plug-in Thermal Sensor
5551R Rate of Rise and fixed temperature detector
DH200LP Low Flow Photoelectric Duct Detector, 2-Wire
DH200RLP Low FLow Photoelectric Duct Detector, 4-Wired
2251TMB Acclimate
7251 Pinnacle Laser
Figure 3: Panel Removed From Network
HS-3030 HS-3030
HS-3030
HS-3140/3434
HS-3140/3434