32
INSTALLING WITH LAP/SHOULDER
OR LAP-ONLY BELT SYSTEM
! WARNING
:
UAS anchors must be
stored when using vehicle belt.
Clip together both UAS connectors
behind backrest ❶.
1. Place the child restraint flush
against the back of a forward-
facing vehicle seat. Adjust the
recline as necessary (see “Recline”,
pg. 29).
2. Thread the vehicle seat belt
through the belt slot opening
and out the other side. See
illustrations for proper routing
path of Lap/Shoulder Belt ❷ or
Lap-Only Belt ❸.
3. Buckle the vehicle belt. The vehicle
seat belt
MUST NOT
be twisted.
To engage vehicle seat belt retractor:
4. Pull out the full length of the seat
belt (until you cannot pull out
any more slack). This locks the
retractor.
5. Tighten vehicle seat belt by placing
your knee on the seat base and by
using your full weight to push the
child restraint down ❹ as you
❶
6. Secure the top of the child restraint using the Top
Tether strap (see “Using Top Tether”, pg. 25).
7. Conduct a safety check for secure installation
(see “Installation safety check”, pg. 33). Perform
this test every time you drive with your child and
whenever you readjust the child restraint as your
child grows.
❷
❸
❺
❹
