3-1 Receiving inspection
Installation
3-1
1
2
3
4
5
6
7
8
9
10
11
Apx
In
sta
lla
tio
n
3-1
Receiving inspection
Check the following items after unpacking the package.
Verification steps
1
Check the items thoroughly for damage sustained during transportation.
If any item is damaged, immediately contact the dealer.
2
Check if the actuator is what you ordered.
The nameplate is found on the rear end face of FHA-C mini series actuator. Check the TYPE
field on the nameplate to confirm that it is indeed the model you have ordered. If any item is
wrong, immediately contact the dealer.
Refer to the section [1-2 Model] (P1-2) in this manual for the detail of the model codes.
3
Check if the servo amplifier combinations are correct.
Check that this is the model combination given in this document in [1-3 Combinations with servo
amplifier and extension cables] (P1-3).
4
Check if the input voltage being input are correct.
The value of the power voltage input is shown in the servo amplifier nameplate “INPUT” column.
If the voltage to be supplied is different from the label voltage, immediately contact the dealer it
was purchased from.
Do not combine with an actuator other than the one given in this
document.
The characteristics of the servo amplifier have been adjusted according to the
actuator. A wrong combination of “servo amplifier” and “actuator” may cause
inadequate torque or overcurrent that may cause burn damage to the actuator,
injury or fire.
Do not connect a supply voltage other than the voltage specified
on the servo amplifier’s nameplate.
Connecting a power supply not matching the input voltage specified on the
nameplate may result in damage to the servo amplifier, injury or fire.
WARNING
