Harman Martin Exterior Wash 300 Series, User Manual

Page: 6 / 40

6 Martin
®
Exterior Wash
TM
300 Series User Manual
Read this manual before installing, powering or servicing the fixture. Follow the safety
precautions and observe all warnings in this manual and printed on the fixture.
The latest version of this manual is available for download from the Exterior Wash 300, 310
and 320 pages of the Martin® website at www.martin.com. Before you install, operate or
service an Exterior Wash 300 series fixture, check the Martin website and make sure that
you have the latest user documentation for the fixture. Document revisions are indicated at
the bottom of page 2.
Refer any operation not described in this user manual to Martin® Global Service or an
authorized Martin service agent. The light source contained in this lighting fixture may be
replaced by Martin or an authorized Martin service agent only.
Install, operate and service Martin products only as directed in their user manuals, or you
may create a safety hazard or cause damage that is not covered by product warranties.
Keep this user manual for future use.
Protection from electric shock
This fixture is IP66 rated. It is suitable for use in wet locations, but do not immerse it in
water or install it in a location where it may become submerged.
This fixture is a Class I product according to IEC 61140. Ensure that the fixture is
electrically connected to ground (earth).
Disconnect the fixture from AC power when not in use.
Supply the fixture with AC power only at the voltages specified in this user manual and on
the product’s serial number label.
Do not open the fixture or remove any cover. Refer any service operation not described in
this manual to an authorized Martin Service partner.
Shut down power to the entire installation at the main power distribution board and lock out
power before carrying out any installation or maintenance work.
Use only a source of AC power that complies with local building and electrical codes and
has both overload and ground-fault (earth-fault) protection.
Isolate the fixture from power immediately if any seal, cover, cable, or other component is
damaged, defective, deformed or showing signs of overheating. Do not reapply power until
repairs have been completed
Before using the fixture, check that all power distribution equipment and cables are in
perfect condition, are rated for the current requirements of all connected devices, are
protected to IP67 or higher and are of suitable type for the location (including water,
pollution, temperature and UV resistance).
Protection from burns and fire
Do not operate the fixture if the ambient temperature (Ta) exceeds 45° C (113° F).
The surface of the fixture can reach up to 70° C (158° F) during operation. Avoid contact by
persons and materials. Allow the fixture to cool for at least 10 minutes before handling.
Keep flammable materials well away from the fixture. Keep all combustible materials (e.g.
fabric, wood, paper) at least 10 cm (4 in.) away from the fixture.
Ensure that there is free and unobstructed airflow around the fixture.
Do not illuminate surfaces within 20 cm (8 in.) of the fixture.
Do not attempt to bypass thermostatic switches or fuses.
Do not modify the fixture in any way not described in this manual or install other than
genuine Martin parts. Do not stick filters, masks or other materials onto any lens or other
optical component. Use only accessories approved by Martin to modify the light beam.
The fixture’s optical components can focus the sun’s rays, creating a risk of fire and
damage. Do not expose the front of the fixture to sunlight or any other intense light source.