Harman Martin Exterior Wash 300 Series, User Manual

Page: 14 / 40

14 Martin
®
Exterior Wash
TM
300 Series User Manual
Installing a snoot
The optional snoot for Exterior Wash 300 Series fixtures can be installed with or without a diffuser lens
(see earlier in this chapter).
To install a snoot:
1. Shut down power to the fixture and allow it to cool.
2. If required, install a diffuser lens as described earlier in this chapter.
3. Note how the profile of the snoot fits into the front of the fixture (see arrows in illustration below). Line
up the snoot correctly, making sure that screw holes in the snoot line up with threaded holes in the
front of the fixture, then fasten the snoot securely onto the fixture with the supplied screws.
Figure 7. Snoot installation
Installing a snoot over a louver
The optional honeycomb louver and snoot can be installed together, with or without a diffuser lens. If you
install the snoot over the louver, a small groove will be visible between the snoot and the fixture housing.
The groove is normal – do not over-tighten the snoot screws trying to remove it.