40
VTX A
6
| Rigging Manual
STEPS:
• With the Case Bottom installed, lower the array until the front wheels touch the ground. The array should start to roll backwards
slightly and, as the array is lowered, the cabinet-to-cabinet angles of the bottom four boxes will close to 15 degrees.
• Once the lowest four boxes are entirely collapsed and the gap between the fourth and fifth cabinets from the bottom is closed,
set the angle selection QRPs on the bottom four A6 cabinets to the STORAGE position (15º).
• Close all eight RED Locking latches.
• Remove the rear QRPs joining the fourth and fifth lowest cabinets. These QRPs should move easily, as the weight of the array
is being held by the front wheels of the Case Bottom resting on the ground.
• Raise the array and allow the four A6 cabinets to roll forward until the cart is resting safely on all four wheels. When the A6 cab-
inets on the Road Case Bottom reach this position, stop lifting the array. Remove the front QRPs and separate the suspended
array from the stack on the Road Case.
9.2 CLOSE THE ANGLE LOCKS AND MOVE PINS TO STORAGE
1
2
3
4
5
1
2
4
3
5
Summary of Contents for JBL Professional VTX Series
