Encoder Configuration Options
29
N2151/N2251 User Manual
Audio Encrypt
Enable to encrypt the audio stream.
Encryption is on by default. Turn off encryption to
allow for compatibility with other devices that require
a decrypted stream.
Brightness
Use sliders to raise or lower RGB values of the Encoder
(POST-ENCODE).
Only affects analog video. Does not affect digital
video.
Component Sync
Window
Use this slider to configure the sync on green
sensitivity.
Used for computer video input to help with screen
flickering.
Input audio for
HostPlay
Enable to activate the input audio when the Live/Local
menu is set to one of the local images.
HostPlay for
Unsupported
Enable to cause the Encoder to use a custom image
whenever an unsupported video mode is supplied to it.
Gratuitous ARP
Enable the Encoder to send a periodic Address
Resolution Protocol (ARP) packet to the network.
ARP Interval (secs)
Determine how often (in seconds) the unit transmits
gratuitous ARP packets.
Unsolicited Status
Enable the Encoder to send a periodic status packet to
the
Send Status Address
described below.
Send Status Address
When
Unsolicited Status
is enabled, the Encoder sends
a periodic status packet to the IP address specified
here.
Status Interval (secs)
Determine how often (in seconds) the unit transmits
status packets.
Discovery Packet
Transmit
Enable the multicast discovery service (which is used to
identify units).
This is useful for larger network integrations when
multicast packets will not cover the entire network.
Enabled by default.
Discovery Interval
(secs)
Determine how often (in seconds) the unit transmits
discovery packets.
TTL
Select the Time To Live (TTL) for the transmit audio and
video streams.
Limits the lifespan of data on the transmit audio and
video streams (to improve performance).
DSCP #
Select the Differentiated Services Code Point (DSCP) for
the transmit audio and video streams.
Serial Master Enable
Enable this device to be the master to the
designated
client
.
The unit stops responding to outside RS232
commands when in Serial
Client
Mode. Can
be disabled to start responding again.
Serial
Client
Address
Enter the IP address of the serial
client
device.
IR Command Holdoff
Set the delay between IR command portions. The
default setting is 25 ms.
IR commands are sent in two parts. This setting is the
time (in milliseconds) between transmission of part
one and part two. The second part of the command is
inverted for confirmation purposes.
IR Repeat Holdoff
Set the repeat delay between IR commands. The default
setting is 90 ms.
This is the amount of time before a new command is
sent. For example, when pressing and holding the
volume button on a remote control, this is how long
until the command is repeated.
Enable SNMP
Enable to allow the device to handle Simple Network
Management Protocol (SNMP) queries.
Report Uncompressed
Stream
Enable to have the Encoder default to the
uncompressed stream upon reboot.
Relaxed Analog Input
Timing
Enable to allow small variances in the analog input (to
avoid video interruption).
Interleaved Multicast
Stream
Enables a multicast format which interleaves video and
audio streams.
In order for N-Series devices to communicate with
each other, their multicast settings must be
compatible.
TABLE 2
Settings Page: Advanced Settings (Cont.)
Option
Description
Notes
