Installation and Upgrading
18
NI-2100/3100/4100 - Hardware Reference Guide
3.
Thread the cables through the opening in the equipment rack. Allow for enough slack in the cables to accommodate for
movement during the installation process.
4.
Reconnect all cables to their appropriate source/terminal locations. Refer to the
for more detailed wiring and connection information.
Verify that the terminal end of the power cable is not connected to the power supply before plugging in the 2-pin power
connector.
NOTE:
To avoid repeating the installation, test the incoming wiring by connecting the Controller’s connectors to their terminal
locations and applying power. Verify that the unit is receiving power and functioning properly. Disconnect the terminal end of the
power cable from the connected 12 VDC-compliant power supply.
5.
Slide the unit into the rack until the attachment holes, along both sides, align to their corresponding locations on the mounting
brackets, as shown in FIG. 7.
6.
Secure the AC-RK to the rack by using the four #10-32 screws (80-0186) and four #10 washers (80-0342) supplied in the
kit.
7.
Apply power to the unit to complete the installation.
FIG. 7
Mounting Integrated Controller into an equipment rack
Install screws
Bracket
Rack Mounting Holes
Rack Mounting Holes
Install screws
