Harman AMX CTC-1402, User Manual

Page: 28 / 64

User Manual - CTC-1402
29
Display
In this column, control of the displays is available. Auto Display Control
• ON: Click to enable Auto Display Control.
• DELAY TIME (1~30 min): Click the down arrow to set the time for the display to power off automatically when no
signal is present. Example: With the time set to 2 minutes, the output display will be powered off automatically when
there is no signal input for 2 minutes.
• OFF: Click to disable the Auto Display Control. (Default setting).
RS232 Setting
In this column, users can select the RS232 control mode.
• CONTROL: Slide the button to select RS232 control mode.
• Local (default):
Local sending of commands to control the projector. Netlinx: Sending commands via NetLinx studio to
control the projector.
• DEVICE: When “Netlinx” is selected, click the down arrow to select TX or RX for RS232 setting.
• BAUD RATE: Click the down arrow to select the baud rate.
• PARTY BITS:
Click the down arrow to select the parity bits.
• DATA BITS:
Click the down arrow to select the data bits.
• STOPS BITS: Click the down arrow to select the stop bits.
• END FLAG: Select the ending flag after each RS232 command.
• POWER ON: Enter the RS232 command to turn on the projector and screen, then click the “SAVE” button to take
effect.
•
POWER OFF:
Enter the RS232 command to turn off the projector and screen, then click the “SAVE” button to take
effect.
• APPLY: Click “APPLY” to take effect.