Hardy Process Solutions HI 6110, User Manual

Page: 35 / 137

HI 6600 Series Modular Sensor System User Guide
Page | 35
Ordering the Weight Processing Modules
The order in which the channels appear in the drop down menus or on the optional front panel display may be changed by
using the SWAP CHANNEL function in the web server or by selecting the channel in front panel display, pressing enter
to ‘capture’ the channel, moving it by using the UP/DOWN arrows, then pressing enter again to ‘release’ the channel to
its new position.
The SWAP CHANNEL function is useful when there is a desire to match the displayed channel sequence to the actual
physical location of the modules on the system (ie: CH1 nearest to the Gateway Module, CH30 furthest from the
Gateway).
Deleting Channels
Use the DELETE function to remove an unwanted module from the system or unwanted channel information that was
previously saved in the memory of the Gateway Module. This function is often used when replacing a damaged module
with a new module or when deleting the presence a spare module from the drop-down menus during normal operation.
Note: Remove the deleted Weight Processor Module by disconnecting the RJ45 connectors
and using a screwdriver to disengage the spring-clip as shown in Chapter 3.
Replace Channel
In the event of a damaged module, the REPLACE CHANNEL function can be used to easily transfer settings from a
damaged module to a new module placed on the system.
Use the following sequence:
1) Power off system
2) Remove damaged module
3) Connect replacement module
4) Power on system
5) Select REPLACE CHANNEL
The replace channel function initiates discovery and automatically transfers settings from the removed (missing) module
to any new module placed on the system.
AVERTISSEMENT – Modification des canaux en utilisant la fonction DELETE modifie le numéro
de canal attribué et où ses données sont écrites de la table I / O .
WARNING - Modifying channels by using the DELETE function alters the assigned channel
number and where its data is written the I/O table.
AVERTISSEMENT – Modification des canaux en utilisant la fonction SWAP modifie le numéro
de canal attribué et où ses données sont écrites de la table I / O .
WARNING - Modifying channels by using the SWAP function alters the assigned channel number
and where its data is written the I/O table.