Page 17 of 18
C
U
S
-0
1
3
-0
0
2
7
-0
2
•
Using a soft towel, gently wipe the top of the burner and
carefully clean the flame sensor (Figure 7-3). Replace the
covers.
•
Try starting the rotisserie again. Pull out the main ON / OFF
switch.
If the rotisserie goes into safety lockout again, there is most likely a
component failure. Turn the rotisserie OFF and contact your local authorized
Hardt service provider.
7.3 Replacing the Halogen Lamp
1. Turn rotisserie OFF (push in main ON/OFF switch) and disconnect
the power cord from the wall receptacle.
2. Allow rotisserie to cool down.
3. Remove the light access panel located on the left side of the
rotisserie by loosening the thumb screws (by hand or using a
screwdriver) (Figure 7-4).
4. Loosen the wing nuts on the light support bracket in order to access
the light (Figure 7-5).
5. While wearing gloves, gently pull the light bulb out of its fixture
(Figure 7-6).
6. Install a new bulb.
7. Position bracket so that the light is oriented towards the center shaft
of the rotisserie. Hand-tighten the two wing nuts.
8. Reinstall access panel.
9. Plug the power cord back into the wall receptacle.
10. Turn the rotisserie ON (pull out main ON/OFF switch).
11. Verify that the replaced bulbs function correctly (it is normal for the
lights to take about 6 seconds to light after the main switch is pulled
to ON). If not, repeat the first four steps of this procedure and make
sure the bulb was correctly inserted in the socket. Reinstall the
access panel, turn the rotisserie ON and recheck. If problems persist,
contact your local authorized service partner.
Figure 7-3: Burner & Flame Sensor
Figure 7-4: Light Access Panel
Figure 7-5: Loosen/Tighten Wing Nuts
Figure 7-6: Replace Bulb
Flame Sensor
Burner
Remove Screws
Do not touch the replacement bulb with
bare fingers or dirty gloves.
