Hardi MUSTANG 3500, Operator'S Manual

Page: 27 / 68

24
HARDI ® MUSTANG 3500 OPERATOR’S MANUAL
Installing Pressure Transducer
The optional pressure transducer is installed in one of the section feed
hoses. A 3/4" tee (#322048) is installed in a convenient place in the
hose (between the control and the boom). In a 3-feed boom, install the
pressure transducer on the center hose. In a 4-feed or higher boom,
install the pressure transducer on one of the center hoses (whichever
is closest to the control). Thread the pressure transducer onto the tee.
Route the cables back to the HARDI
® Sprayer Control Module and plug
the two wires into the appropriate terminals.
ADAPTER CABLE COLOR CODE
Wire color DESCRIPTION
RED +12V supply
BLACK Signal
PRESSURE TRANSDUCER COLOR CODE
Wire color DESCRIPTION
BROWN +12V supply
BLUE Signal
Route the Pressure Transducer Cable to the HARDI ® Sprayer Control
Module. Mate the wires as shown below. Be sure to slide a piece of
heat shrink tubing over each wire before mating. Then shrink tubing
by applying heat evenly along tube. Plug adapter cable into Sprayer
Control Module pressure input, pigtail with Natural colored tie.
Black Blue
Pressure Sensor
2 wire adapter cable
Brown
Red