Hardi JAZZ, Instruction Book

Page: 8 / 36

8
6. Fit the shaft to tractor and sprayer
pump.
NOTE: Female part towards tractor.
Fit the chains to prevent the
protection guards to rotate with the
shaft.
7. To ensure long life of the transmis-
sion shaft, try to avoid working
angles greater than 15
°
.
8. Transmission shafts with cone
must be fitted by tightening the
Allen screw to a torque of 40 Nm.
Check again after 2 minutes use.
Rear lights (if fitted)
Connect plug for rear lights to the tractors 7-poled
socket and check that rear lights, stop lights and direction
indicators work properly before driving anywhere.
The wiring is in ISO accordance. See section on Technical specifications.
Roadworthyness
When driving on public roads and other areas where the highway code
applies, or areas where there are special rules and regulations for marking
and lights on implements, you should observe these and equip implements
accordingly.
Operating instructions
Filling the main tank
Water is filled into the tank by removing the tank lid located at right hand
side of sprayer tank. It is recommended to use as clean water as possible
for spraying purposes. Always fill water through the strainer basket to
prevent foreign particles from entering the tank. An overhead tank can be
used in order to obtain high filling capacity.
WARNING: Do not let the filling hose enter the tank. Keep it outside the
tank, pointing towards the filling hole.
If the hose is lead into the tank and the
water pressure drops at the water supply
plant, chemicals may be siphoned back
and contaminate the water supply lines,
plant and well.