Hardi JAZZ, Instruction Book

Page: 6 / 36

6
Connecting the sprayer
The sprayer is designed for three point suspension and is equipped with
22 mm pivots (category I).
WARNING: Note the weight of the sprayer. General recommendations are
as follows:
• Add ballast to front of tractor.
• Increase tyre pressure
(see tractor instruction book).
• Be careful when filling/lifting the sprayer for
the first time.
• Ensure the operating unit and tractor do not touch.
• Travel at slower speeds when driving with a full tank.
(The tractor braking effect will be reduced.)
Transmission shaft
Operator safety
To avoid accidents and personal injuries, note the following recommended
precautions and safe operation practices.
Always STOP ENGINE before attaching the transmission shaft to tractor
P.T.O. - most tractor P.T.O. shafts can be rotated by hand to facilitate
spline alignment, when engine is stopped.
When attaching the shaft, make sure that the snap lock is FULLY EN-
GAGED - push and pull shaft until it locks.
WARNING: ROTATING TRANSMISSION SHAFTS WITHOUT PROTEC-
TION GUARDS ARE FATAL
Always keep protection guards and chains intact and make sure that it
covers all rotating parts, including cross journals at each end of the shaft.
Do not use without protection guard.
Do not touch or stand on the transmission shaft when it is rotating - safety
distance: 1.5 metre.
Prevent protection guards from rotating by attaching the chains allowing
sufficient slack for turns.
Make sure that protection guards around tractor P.T.O. and implement
shaft is intact.