TRIGGER ASSEMBLY FOR SIDE RAILS OR
JOHNS HOPKINS HANDLE REPLACEMENT
4. Remove screw holding the shield plate and center trigger
bracket. Remove the shield plate.
1. Turn rail upside down and remove acorn nut and
lock washer from the retainer block.
2. Push retainer block down and twist to one side as
shown to disengage the screw from the metal bracket
on the shield plate.
3. Lift to remove handles from the trigger bracket inside the
rail tube.
If only the Johns Hopkins Handle assembly is
being replaced, skip to Step #9 next.
It is necessary to remove the rail from the crib prior to the steps listed below. Please follow
the instructions on the prior pages to remove the rail and the slide rods prior to beginning
the repair. Reference the page for Side Rail Assembly Diagram if needed to identify parts.
5. Remove the entire trigger assembly by pulling it out one side
of the rail.
If you are unfamiliar with changing a trigger on one
of our cribs or beds, note how the components lock together
for reassembly.
16