Harbor Freight Tools Central Machinery Industrial 95302, Assembly And Operation Instructions Manual

Page: 18 / 32

Page 18 SKU 95302
for technical questions, please call 1-800-444-3353.
When cutting a large workpiece, make sure its entire length is properly supported.
If necessary, use a roller stand (not included) with a larger workpiece.
Allow the Saw Blade (251) to turn up to full speed before feeding the workpiece into
the Saw Blade.
(See figure P.)
WArNING! Always keep hands and fingers safely away from the cutting
area.
Feed the workpiece into the Saw Blade (251) gradually. Do not force the Bandsaw to
remove material faster than it is designed to cut.
Never attempt to remove material
stuck in the moving parts of the Bandsaw while it is plugged in and running. Turn
off the Bandsaw if the workpiece is to be backed out of an uncompleted cut.
Once the cut is made, turn the Motor Toggle Switch (750-5) to its “Off” position.
Turn the Coolant Pump Toggle Switch (750-5) to its
“Off” position. Turn the Cool-
ant Pump Fitting (91S) to its “CLOSED” position. Then, unplug the Power Cable
(500) from its electrical outlet.
(See figure P.)
Wait until the Saw Blade (251) comes to a complete stop. Then, remove the work-
piece and scrap material from the Large Vertical Cutting Plate (867).
(See figure P.)
Turn the Cylinder (216) to its “ON” position. Slowly lower the Saw Head to its hori-
zontal position. Then, turn the Hydraulic Cylinder to its
“Off” position to lock the
Saw Head in place.
(See figure P.)
Basic Bandsaw Operation -- Horizontal Position:
WArNING! Always wear ANSI approved safety impact eye goggles when operat-
ing the Bandsaw.
Do not plug the Power Cable (500) into an electrical outlet until all necessary
adjustments (as previously discussed in this manual) have been made.
Turn the Cylinder (216) to its
“ON” position, and raise the Saw Head to its full verti-
cal position. Then, turn the Cylinder to its
“Off” position to lock the Saw Head in
place. (See figure Q, next page.)
Secure the workpiece in the Vise assembly (9, 22). When cutting a large workpiece,
make sure its entire length is properly supported. If necessary, use a roller stand
(not included) with a larger workpiece.
(See figure Q.)
If cutting several work pieces at the same length, you may wish to adjust the Stop
Block (41) to the desired position.
(See figure I.)
Once all necessary adjustments to the Bandsaw have been made, plug the Power
Cable (500) into the nearest
115 volt, grounded, electrical outlet.
11.
12.
13.
14.
15.
16.
17.
1.
2.
3.
4.
5.
6.