Harbor Freight Tools Central Machinery Industrial 95302, Assembly And Operation Instructions Manual

Page: 10 / 32

Page 10 SKU 95302
for technical questions, please call 1-800-444-3353.
UNPACKING
When unpacking, check to make sure all the parts shown on the
Parts Lists near
the end of this manual are included. If any parts are missing or broken, please call Harbor
Freight Tools at the number shown on the cover of this manual as soon as possible.
ASSEMBLy INSTrUCTIONS
Note: For additional information regarding the parts listed in the following pages, refer to
the
Assembly Diagrams near the end of this manual.
CAUTION! Always make sure the Toggle Switch (750-5) for the Bandsaw and
the Toggle Switch (750-5) for the Coolant Pump are both in their
“Off” position and
the tool is unplugged from its electrical outlet prior to assembling the tool, adding
any accessories, or making adjustments to the tool.
CAUTION! Always wear heavy-duty work gloves to protect from sharp metal
edges.
To Attach The Wheels:
NOTE: This Bandsaw weighs approximately 275 pounds and you will need the
assistance of additional personnel and an adequate lifting device.
Use a lifting device to raise the right side of the Stand (77S) of the Bandsaw about
six inches off the floor. Once the Stand is lifted, insert a Wheel Rod (92-4) through
the two holes located at the bottom of the Stand. Slide one Wheel (92-2) on each
end of the Wheel Rod. Place one Washer (92-1) on each end of the Wheel Rod.
Insert one Cotter Pin (92-3) through the hole in each end of the Wheel Rod. Make
sure to bend the Cotter Pins to secure the Wheels in place. Then, lower the Stand
to the floor surface.
(See Assy Diagram, page 30.)
To Attach The Levelers:
NOTE: For this procedure, you will need the assistance of additional personnel
and an adequate lifting device.
Use a lifting device to raise the left side of the Stand (77S) of the Bandsaw about
six inches off the floor. Once the Stand is lifted, screw in the two Levelers (93-2)
through the two threaded holes located at the bottom of the Stand. Lower the Stand
to the floor surface. Then, use the accessory Level (866) to properly level the Stand.
(See Assy Diagram, page 30.)
1.
2.
1.
2.