E
14
9-wire
Plug
9-wire
Plug
3.
3
Remove three switch housing screws (Q) from
fitter plate (on underside of motor). Connect 9-wire
plug from motor housing (E) to 9-wire plug from
switch housing (F), matching up the colors on the
9-wire plugs for correct fit. (Fig. 3) Make sure plugs
connect tightly.
Carefully arrange wires inside switch housing (F).
Align holes in switch housing (F) with holes in fitter
plate. Re-insert switch housing screws (Q) that
were previously removed. Tighten all three switch
housing screws (Q) securely. (Fig. 3)
FINAL INSTALLATION
F
4. Locate switch housing screws (Q) on underside of
switch housing (F) rim. Remove switch housing screw
(Q) with a red dot--save for later use. Partially loosen
the other two switch housing screws (Q). (Fig. 4)
Align slotted holes in light kit fitter (I) with loosened
screws in switch housing (F). Twist light kit fitter (I) to
lock. Re-insert switch housing screw (Q) that was just
removed, and then tighten all three switch housing
screws (Q) securely. (Fig. 4)
4
I
F
Q
Switch
Housing
Rim
5.
Fitter
Plate
Q
Q
E
5
J
Small
Female
Plug
Small
Male
Plug
F
I
Connect small male plug from
switch housing
(F) to
small female plug from
light kit fitter
(I), (Fig. 5)
Make sure plugs connect tightly.
Install three candelabra-base 40-watt max. bulbs (J)
included. (Fig. 5)
CAUTION:
When replacing bulbs, please allow
bulbs and glass shade to cool down before touching.
