13
FINAL INSTALLATION
B
P
K
A
1.
2.
Hardware Used
Locate two canopy mounting screws (P) on
underside of mounting bracket (C) and remove
canopy mounting screw (P) closest to the open
end of the mounting bracket (C). Partially
loosen the other canopy mounting screw (P).
Lift canopy (B) to mounting bracket (C). Place
rounded part of slotted hole in canopy (B) over
loosened canopy mounting screw (P) in
mounting bracket (C) and push up. Twist
canopy (B) to lock. Re-insert canopy mounting
screw (P) that was removed, and then tighten
both canopy mounting screws (P). Slide
canopy cover (K) up to canopy (B). Press up
gently but firmly on canopy cover (K) until you
hear it snap onto the bottom of the canopy (B).
(Fig. 1)
1
Insert the blade (G) through the slot on the band
on the motor housing (E). Align holes and attach
the blade (G) to the motor with blade screws
(AA) and fiber blade washers (BB) provided.
Then, tighten each blade screw (AA) starting
with the one in the middle. (Fig. 2) Repeat for
remaining blades (G).
Time Saver
: Fiber blade washers (BB) can be
set on each blade screw (AA) prior to installing
blades (G).
AA
Blade Screw x15
Fiber Blade Washer x15
BB
Slot
G
E
AA
BB
2
